Positive E Solutions Inc. offers a wide variety of bridges & adapters to connect any storage media to different interface. With bridges and adapters you can use low-cost media with a higher end device or the other way around.

SCSI to IDE Bridge Adapter

Convert any IDE/UDMA/ATA 40-pin device to a USCSI-II & III 50-pin device so that it is seen as a SCSI device (Hard drive, CD, Scanner, Tape Drive, etc.) by your SCSI adapter or SCSI RAID Controller.

These adapters can provide your existing SCSI Systems (Mac, SUN, PC) with capability to use low costs IDE devices without Sacrificing your SCSI speed and configuration.

The USCSIDE-BR2 Ultra SCSI-IDE bridge is dedicated to general purpose bridge of SCSI (Small Computer System Interface) to IDE (Integrated Device Electronics )interface.

With the micro-controller core built-in, it provides more flexibility and stability for highly exploring application.
The USCSIDE-BR2 supports IDE device which can be easily attached to SCSI bus.

Features

• On-chip high speed RISC micro-controller.
• SCSI controller, IDE controller and interfaces.
• SCSI host interface synchronous transfer rate up to 20 MB/sec.
• On board Flash ROM for easy firmware upgrade.
• Full Ultra SCSI target features support.

Specifications

• On-chip high speed RISC micro-controller
• SCSI host interface synchronous transfer rate up to 20 MB/sec
• On board Flash ROM for easy firmware upgrade
• Selectable SCS ID from 0 to 7
• Full Ultra SCSI target features support

Support Hard Disk: